There are a couple ways to fix it. I have done both with success
I have welded 3 diesel tanks on tractors. I use heatvgun to warm the area and keep it warm. Brake clean and wire brush to make it spotless clean
Saran Wrap for the weld.
Take Saran Wrap in a speed drill and squat it into a stick. Make sure it is very clean. Heat the area and use an electric wood burning tool as the melter. Slowly burn into the tank filling with plastic as you go. Layer on layer till you think its strong enough not to break again.
The underside of tanks I find flex to much do there I use high heat silicone and steel plates. The biggest plate that fits in the filler hole. I put one on the inside and one on the outside.
Inside one needs no silicone. Pre drill and weld nuts onto the one inside. The one on the outside use lots of silicone and bolt together. Sometimes you need to weld wire to it and break it off when finished. Magnets taped to sticks works. Sometimes a magnetic through the tank works to move it around a bit.
I have not had one fail that I fixed yet. Knock on wood.
It is way easier if the tank is off no matter which method you use.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
