Thank you to all who took time to opine. Forgive me for not getting into overall details of project but the question comes down to how much if any oil film does it take before clutch suffers more than can be tolerated. On the other hand I fear simply asking if oiling a new pressure plate at installation is a good or poor idea would make me look like a bigger fool than the way I chose. Since I'm unable to follow the consensus of doing the job in a few days as it's conventionally done,I'll apply oil then wipe away as much as possible without using solvent and trust it does the job. Part of reasoning behind this decision is in the 50s I witnessed many cars,trucks and tractors with oil soaked clutches from rear main leaks. If vehicle got to point it wouldn't pull,a short term solution was put the front bumper against a tree and slip clutch to burn oil off. Sure wish I had videos of that and a few other home remedies at the time. In my pea size brain it seems one of those tree pushing secissons burned off more oil than I would apply in this case. In hindsight I wounder if the county oiled some of those roads or if cars kept them oiled. Thanks again for participating ,now back to regular program.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.