There are plenty of companies that will cross border equipment for you. Some are Valley transportation in Grand meadow MN, Gibbons in Canada, Landstar, even some of the other bigger companies will do it. These are just a few. I have no idea of cost anymore. For the tracks a flatbed will be cheaper and The cart will need a lowboy/detach to haul it so if you could get them on there with the cart it would save you some cash. Load the tracks behind the cart on the rear deck or on the neck then cart would have the whole well by itself. This would depend on the size of the cart and length of the tracks. Rubber or steel. If rubber and to long for the rear deck I would load them on the top after cart was loaded if I could and set tracks on top with them hanging off the back of the top deck so I didn't exceed the 53ft length. For a bigger cart ask for slide out outriggers like for hauling sprayers and combines, with less chance of a tire being ruined by sliding off the side as it is being loaded. My detach has the slide out version. You will also probably be in the oversized load position so that will also add to the price and would probably eliminate the hotshot guys. Not by weight necessarily but by truck size. MI permits require a 1-1/2 ton truck for oversized loads even though I see loads moved with pickups. I don't know if the load is being moved without permits or nobody looks at the permits.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
