Posted by Tslinger on November 01, 2023 at 02:39:31 from (69.74.110.34):
I'm kinda casually on a slow speed search for a tractor to dedicate to my Mott flail. I've used it happily with my MF 135, but I have to remove the lift links and replace them with chains so I get independent float on the arms. I always thought that better described as roll, but either way that's what it needs to follow the ground.
Obviously it isn't the end of the world to change it over, but it isn't fast either when I want to go back to the pallet forks, which absolutly can't have that feature.
Does that warrant another tractor? Well, that's why it's a slow speed search...
I know some tractors have that flexibility built in to the lift links. It isn't something that gets called out when you're looking at used equipment ads though.
For example, there's this International 485 listed that's basically in the size/capability/age range I'm looking in. Looking at the photos, there would seem to be something going on with the lift links. There's gotta be a reason for the various bumps, bulges, and pins, but nothing is screaming out at me. This is a photo of a replacement lift link for that model...
Does it float? Thoughts?
Better options in that late 70's early 80's 45-55 horse range? The 485 really does look nice in the photos, but I haven't made the trip to see it, and I've never personally been around International gear to know their quirks.
I could just leave it on the 135, and get something for the other tasks, but I'd really like to find something a little easier to run, so my other half wouldn't have an issue. Power steering, and an independant PTO rather than that stiff two stage clutch pedal on the 135. New obviously isn't an option since I haven't hit the lottery yet...
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
