If the tractor is heavy enough the height from utility to row crop would not be a big factor another words if you used a 2630 or a 4020 the 4020 would be just as good at the bale work and better for some things than the 2630. though the bigger tractors can be bought for about the same money as some of the MFWD models in newer tractors to get the MFWD. Now for the models /brands IH has a slow low volume pump in them with adequate pressure for most things. The Deere will have a bigger pump volume with same or higher pressure system. Most of the tractors in the 2630 era will not necessarily have real robust hydraulic systems due to most were in the 10-15 GPM with from 1500-2500 PSI for loader work your looking for more in the 15+ GPM with the 2000+ PSI. MFWD is desireable though not necessary. So now for models the 30,40,50 series would work well for your endeavor in Deere IH the 84series in the utility on up or in row crops the 56 series up would work for you. Case the 30 series tractors would work well. I always thought the Fords and Feries were a bit light for loader work in the rear end. Needed to add a lot of weight to get them to where the rest of the comparable models were there. There are others with less support than the ones listed.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
