Good comments... and I found out that I HAD to have the correct ground speed for a sycle to work correctly.
Too slow and all the cuttings fell on or in front of the guards and prevented new grass from entering correctly. Too fast and you choked the bar down and locked it up...
And when the grass leans away from you, you need a bit fast vs when the grass leans towards you, to clear and keep the guards open.
BUT.. I have 3 new holland 450 series cutters and use the heck out of them.. Any 30 hp tractor is plenty but lots of gears for ground speed is a must. The ford 8 speeds are most perfect while the early 4 and 5 speeds are fair to good. These smaller 30 to 50 hp tractors are also perfect for ground driven rakes. Where the newer round balers need 85 hp to work easily and correctly.
Anyway using a sickle is mostly black magic as the operator MUST keep the ground speed correct for the conditions while the engine is set at 540 pto rpms...
Mowco's are much easier to use as long as youre careful on your turning and avoid fence posts and gates.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
