Posted by DanielW on September 22, 2023 at 07:04:31 from (24.51.248.85):
In Reply to: Snake OIl? posted by Geo-TH,In on September 22, 2023 at 05:16:35:
I don't think ethanol nor any additive meant to remove water from fuel will do much in oil. They work in fuel because the polar nature of the molecule let it bind to the water, but also bind/remain soluble in the fuel. They don't 'get rid of' water in fuel, they just allow it to be mixed/soluble with the fuel so it passes through the system and is burned up/kicked out with the exhaust, rather than having the separate and pool at the bottom of the tank or pickup where it's concentrated enough to freeze. In oil, it's not going to get rid of it, just make it soluble/mixable with the oil, which might be worse for the engine as you're diluting your oil.
I'm a fan of the Lucas heavy duty oil stabilizer for any ag engine, especially ones that sit over winter. It claims to coat all the surfaces in a nice, slick coating that prevents corrosion and reduces friction. I was sold on it after watching a demonstration at the International plowing match. You might have seen a similar demo: They had an old Cat diesel, they'd fill the crankcase with a mix of oil and their stabilizer, run it for a bit. Then the rep would drain the oil and take the oil pan right off, start it up and let it idle away the rest of the day with no oil pan and the crank/rods exposed. The claim was all the bearing surfaces had a good dose of oil stabilizer coating them which would keep them lubricated enough to run with no oil. Seemed like a pretty impressive demonstration to me.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
