Posted by Bill(Wis) on September 08, 2023 at 07:49:22 from (67.86.36.109):
In Reply to: Re: Picking corn posted by Geo-TH,In on September 07, 2023 at 14:10:01:
I believe the term ''picking corn'' goes back to the days when it was picked by hand. then, mechanical pickers were introduced. First ones were single row and either mounted to a tractor or pulled behind a tractor. The ones we used didn't do a very good job of husking so two or three of us would sit on the wagon pulled behind the picker and pull the remaining husks off from the cobs as they came tumbling into the wagon.
The dairy farmers didn't bother shelling the corn off from the cobs. Most beef farmers didn't either. But for chickens and pigs it was best to shell the corn. Corn shellers were used for that. Here is a Minneapolis Moline corn sheller which was considered to be the best corn sheller on the market in 1954. These were usually available thru the local feed mill and towed out to the farm yard with the feed mill truck and then powered with the farmer's tractor. Corn on the cob would be shoveled into the left end hopper and the shelled corn would go up the elevator into a wagon, truck, trailer and the empty cobs would be blown on a pile and could be used for bedding or fuel. .10c per bushel for the service. And then came the combines which could do it all. Here in Central Siberia we call it combining corn or combining beans or whatever. The term ''shelling'' is never heard. It's a regional thing like ''plowing corn''. People around here wouldn't know what you were talking about.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
And then came the combines which could do it all. Here in Central Siberia we call it combining corn or combining beans or whatever. The term ''shelling'' is never heard. It's a regional thing like ''plowing corn''. People around here wouldn't know what you were talking about.