Posted by WeirdDeere on September 08, 2023 at 03:03:26 from (174.207.231.151):
I've always followed the JohnT instructions for polarizing generators. Flashing BAT power to ARM post.
I posted this somewhere and started a mini argument, from a guy who always flashed BAT to FIELD. He stated source as the JD electrical manual.
Others have been on one side or the other.
I did more digging, and apparently it depends if you have an A circuit or B circuit generator on how it's flashed.
But I'm wondering if it's even a hard and fast rule....because we both made either choice work on JD generators? I can't remember if JD used A or B type circuits.
Some more info stolen from the internet.....
---------------
Depends on the circuit in your generator. According to the Delco-Remy service bulletin dated 7-3-61, there are two different circuit types of generators:
Type A circuit - The field winding is connected to the insulated brush inside the generator and is connected to ground through the contact points in the regulator.
Type B circuit - The field winding is grounded inside the generator and is conncted to the armature circut inside the regulator.
To polarize the generator with: Type A circuit - Momentarily connect a jumper lead between the regulator BATTERY and ARMATURE terminals after all leads have been connected, but before the engine is started.
Type B circuit - Disconnect the lead from the regulator FIELD terminal, and momentarily touch the lead to the regulator BATTERY terminal. This should be done after all other leads have been connected and before the engine is started.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.