Posted by JWinIndiana on August 29, 2023 at 08:51:58 from (165.139.32.100):
In Reply to: Tractor hours posted by JWinIndiana on August 28, 2023 at 10:46:43:
Quoting Removed, click Modern View to see
Excellent points and appreciate the breakdown. It is at a dealership. Just talked with him again setting up time to see it tonight as it will be 6pm his time by the time I get there. He will deliver, wants me to take pictures of the Oliver and I have told him no less than 2,500 for it. The hydra power started leaking last fall early winter, put it in the other position and it almost eliminated that leak. I haven't done anything major to the tractor in the time I have owned it unless you call a starter major. Knowing I had to split it for the hydra power I planned on replacing clutch, pressure plate and throw out bearing while it was split. It would be nice to have two big tractors with loaders.
This tractor is from his region, was a sale, he doesn't know the circumstances but it was a liquidation.
He is using the terminology of "operable". He just called, they have an Agri Gold event he forgot about, the tractor will be out and available for me to start, drive, use and get a feel of it. I will take pictures for you folks.
I also voiced concerns about the clutch and we agreed on the phone (I will make sure it is written if I buy this) that he would haul the tractor both ways and charge me for parts only. This would be good for 6 months after purchase. I feel this is more than good faith on his part.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
