Posted by used red MN on August 23, 2023 at 08:40:58 from (72.21.227.18):
In Reply to: JD300 reverser is out posted by neobobstahl@gmail.com on August 23, 2023 at 08:03:05:
Somewhere in the center hole the hydraulic pressure flows to a port to move the piston out to engage the clutch pack. I assume you have it apart due to a ..No drive.. issue. You will probably want to replace the seals on that piston. You will need C clamps or a press to compress the spring while you take off that snap ring. I have never had one of those apart so I do not know how much spring pressure is on it. If I was doing it I would figure out how to air pressure check the piston after installation after the reseal to make sure it is all good. Those bushings in that hub are also important. There has to be some metal or Teflon rings that seal the oil on the inner shaft. The bushings hold that all inline so it can seal properly. Since those bolts rubbed it seems like something is worn and letting things out of alignment. What transmission is this? Is it a 8 speed Powershift with a reverser lever or something else? Do you have a repair manual? If not there are probably a lot of things in there about what you need to look at.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.