I have always been extremely safety-conscious, which is one reason why, despite using dangerous equipment for many years, I have never suffered any significant injury. I was surprised to learn that these covers are intended to improve safety and do not believe that they actually provide much additional protection. Physically, the only possible value they have is in preventing stringy things from getting caught in the U-joints. I don't wear long flapping scarves while using my tractor, nor do I have extremely long bootlaces that I leave untied. I cannot see any safety benefit from these devices. Indeed, by covering the retaining pin in the shaft, they render MORE likely the one (non-injury) accident that I did have with the brush hog. I frequently cast a quick glance back at the brush hog while operating it, just to make sure that everything back there is OK, and those yellow skirts partially conceal its operation.
Yes, weird accidents do take place; I've got a near-unbelievable tale of cutting down an oak tree that fell in an unintended direction (a possibility I was prepared for), and then bouncing off a nearby tree right back at me. As per my standard safety practices, at the first sign of trouble I had fled down a pre-determined route, throwing the chain saw in the opposite direction. The bouncing-back oak tree hit the chain saw and bounced it directly back at me -- the odds of that were a zillion to one. Here, I had a smidge of good luck to counter all the weird bad luck -- the chain saw flew past my knee, and while it ripped up my jeans and tore off some skin, there was no serious damage and I didn't see any need to get medical attention. A couple of band-aids were sufficient and there's no scar.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
