thanks to all the great help and comments i got here when i started this project a little while back i have gotten it kind of stripped down. now just trying to get it clean enough to see if i can get a little fresh paint on it before re-assembly begins.
i have found a rebuilt short block and had the head rebuilt at a local machine shop but before we get to that point.
i did not get to use this machine only to start the motor and hear it banging loudly, the rod bearing on the crank shaft for center cylinder was completely gone, no parts found in oil pan.
i will be inspecting with my limited knowledge all components looking for obvious issues. maybe i should consider a clutch and brakes while i'm where i'm at? rebuild hydraulic pump?
anyone with more knowledge of these things, i would be very grateful for any comments or suggestions on what to look for / at while i'm cleaning and painting? i already see some funny look pin holes at some hydraulic ram connections. but i think at this point i'm most concerned with mechanicals.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
