Posted by JimB2 on May 02, 2023 at 15:05:45 from (174.114.155.238):
In Reply to: Case-IH 3220 Clutch posted by cjafarm on May 02, 2023 at 13:59:36:
Hi my brother has a 3230 and is the same tractor as the 3220 but with the larger D-206 engine. We had to do a clutch replacement on it a year ago as one of the finger adjustment screws on the pressure plate unscrewed itself and we had to split it to fix but the clutch was almost wore out so we did a complete clutch, pressure plate and bearing replacement.
From your description of the problem, I would think that item #5 pin has fallen out or sheared off allowing item #19 to spin in item #4 clutch fork. With a worn clutch item #19 with turn freely almost half a turn, about 2 O'clock to 5 o'clock if I recall correctly but will not do a complete turn. Have you looked up through the inspection plate on the bottom of the clutch housing? I would not worry too much about the broken spring as it's only purpose is to hold a small down pressure on the clutch pedal as item #2 the throughout bearing rides on item #28 thrush washer that fits into the fingers on the pressure plate and the throughout bearing turns all the time. The old 74/84 models had a spring on the clutch pedal that held the clutch pedal in the up position and the throughout bearing only turned when the clutch pedal was depressed and the bearing contacted the pressure plate fingers.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
