Posted by hunnter9 on April 16, 2023 at 06:38:50 from (72.169.80.119):
I have a belarus 500 1990's and someone put a push button start switch to activate solenoid.They ran a wire from battery side of starter to this push button and its also feeding ampmeter off this wire. The starter relay is present but not wired at all.I am installing new 4 position switch with key for glow plugs and acc and start. My question is, do I need the starter relay? I have no clue how to wire this. The relay has 4 terminals 2 on one end marked K and the other end marked C and a symbal in the middle unknown with a terminal. It starts fine the way it is but being wired like this, I have to choke the throttle to turn the motor off and then switch the main power switch off under the seat or battery drains. Can some please tell me in a non schematic way how to wire what I have going? I was going to install switch and put the wire mention from the starter and put on start side of switch this would then let me power my glow plugs when turned left. The remaining wires I was going to put on the acc side that is powered when running. I hope this makes sense, please help.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.