Posted by FAKEITORMAKEIT on April 02, 2023 at 18:11:51 from (76.187.154.53):
Hey yall , long time lurker, first time poster . I have learned so much from this incredible forum so thank yall.
As a back story i was given a 2001 century 2028 tractor . It was so badly abused and mistreated that the folks simply told me to come load it up. It only had 320 hours on it when i got it . But after being drove through a pond and flooded for Lord knows how long i finally went all through the little tractor and got all the seals on the rams changed . Went through and cleaned the motor inside and out , also had to physically scoop hand fulls of gunk out of the hydro reservoir it was horrible. But all in all i got it running like a champ and it has been a good strong tractor and having done all the work myself i learned alot! But one thing that i had to do that was not ideal was i deleted a tone of electrical that was what was once the wiring harness . So no lights , no fuel gauge no seat safety switch and no fuel shut off solenoid. And i rewired new glow plugs on its own new circuit with a toggle switch. It has a front end loader and has been running great . So i borrowed a small 4 foot tiller and when i worked it at the recommended 540 rpm and tilled up a 1/4 acre it started acting fuel starved . So i changed all the fuel filters and even installed a new lift pump and installed it closer to the fuel tanks like within 12 inches of the tank outlets . I drained the tsnks. And blew air back into the tanks and this thing still wont run . Sometimes for 5 minuted and longer if i open the fuel bleed screw. I have fuel gushing out of the bleed screw and the filters are full to the top with fuel. It was running fine before i used the tiller . I just can figure this out. I wonder if there is a electrical component thst is still doing its job partially? Any help would be great and i look forward to hearing from all of you! Ps i also loosened the fuel cap and completely removed it that affected nothing . Its so wild that this only happened after working the pto. It has been running fine with the FEL for a year .
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.