Posted by used red MN on March 08, 2023 at 12:07:48 from (146.209.159.16):
In Reply to: old grease removal posted by 1946 BN IHC on March 08, 2023 at 08:27:31:
I do not know why you would be concerned about your topic, it is way closer to technical discussion then posting what you had for breakfast or what a weather map is saying. Those things have been posted on TRACTOR Talk, all be it they may have been by mistake. I agree with blackhole, if this thing is under 15-20 years old and saw grease twice a year hard grease is not your problem. You say ball joints and tie rod ends what manufacturer made the chassis? Both ball joint and king pin style front suspensions will benefit from being greased with the weight of the vehicle off of them. Most ball joint suspensions use a coil spring or torsion bar to support the vehicle by way of the lower A arm or control arm. These need lifted under the outer end of the control arm closest to the tire to take the pressure off of the ball joints for the most ideal scenario to get grease in between the wear surfaces where it normally would not flow easily if the joint is under tension. If you do not understand what I mean about the ball joint loading post back and I can go into more detail. Maybe all that really needs said is that type of suspension when it is jacked up under the frame and the control arms ..usually the top.. hits it stop. The ball joint is still holding the pressure of the coil spring keeping it from flying out.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
