I made several business trips to Oneonta, NY in the Catskills; very pretty. One observation in the drive to the destination from the airport was the emergence of rocks protruding from the soil a distance of 10-20' at a good angle, huge in size, like plates that shifted and one lost the pushing contest and became airborne.
The other thing along the way was a hillside, surface grassed nicely, about a 30* angle and off in the distance were these what looked to be large (Red Brangus colored looking) cattle grazing the hillside (with dense woods just up the hill). My sponsor corrected me....those aren't cattle, they are deer. I thought my my what a sight. No wonder hunting is popular.
Also enjoyed the little commuter (aircraft) trip from the int'l airport to the airport at the top of a hill near Binghampton, to the Southwest. Since it was a few seat turboprop commuter, the pilot left the cockpit door open and coming in for a landing, on the hilltop you could see what the pilots saw and it was a most unusual, enjoyable experience.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.