Posted by Mtjohnso on February 10, 2023 at 20:46:58 from (172.56.104.99):
Have a SWD9 that my son bought and mounted a blade on the front. The SWD9 has 4 mounting holes on either side of the radiator and 4 more back by the clutch housing on each side. He only mounted this big heavy blade to the mounting holes by the radiator. Bottom line is that we did some pushing of some dirt the casting broke right behind the mounting holes from one side to the other. This damaged the radiator and the fan blades also. I have everything off the tractor and need to reattach the broken cast part which is needed to support the radiator. I have seen where people have brazed cast back together and it has held ( my Super A had the bull gear housing all brazed up before I got it. Still holding together) The blade will not go back on the tractor. So the casting will be supporting the radiator. The cast piece that broke off is about 3 ft wide and about 9 inches in depth. The piece that it gets attached to is about 4 to 5 ft long and 3 foot wide. So heating it up is a problem. I am planning on taking this to a shop, if I can find one. Is this even feasible? What have you seen done and what method was used?
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.