Posted by taem on February 09, 2023 at 07:52:23 from (73.159.136.137):
I would value your thoughts about a situation I've had recently: a couple of years ago I built a 40x60 pole barn for machine storage (tractors among them) with one part gravel floor with stall mats and one part cement slab 4-5. The whole place had a six inch perimeter drain surrounding the telephone pole uprights. The fellow I used to do the drainage, set the poles and pour the slab is someone I've worked with for over 20 years and has been a neighbor. He's done excavator work (he is a genius who can put a teacup on a fence post with an excavator), logging and so forth for me. He's bought beef, hay and other stuff from me and hunts on my land.So, the year following the construction, the slab heaved, cracked and screwed up the sliding door on the end of the barn. I really don't know why, because he's poured lots of slabs, cellars and so forth in our Northern Vermont climate and has had no complaints. My theory is that that they compacted too much over the drainage and water infiltrated under the slab. Anyway, I approached him about fixing it and never really spelled out what the terms would be. I figured he would charge me the materials (more crushed stone and of course the cement) and give me a substantial break on his labor. The bill I got was basically what he would have charged me for the original job, plus some more for a couple of small jobs I needed done around the barn. That didn't sit quite right, and I asked him to lower the bill, which he did by about 20%. He has been pretty chilly with me since then. I feel that I was justified in my expectations, polite etc. and I still would use him if I had another job. What do you guys think? I am more interested in continuing good relations with him than proving any point. Was I wrong to expect him to make the job right?
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
