Bill, if you are holding the biggest problem in your hand in the photo, and those wires go to the big plastic connector, and you have enough length in the wires, take apart the plastic plug first. Like Mman said, the clips on the ends of the wires push into sockets in the plastic connector. Each wire clip has a small flat tab that acts as a barb when the clip is inserted into the connector. Take a finish nail, pound it flat into a small screwdriver-like blade, and slide it into the connector from the opposite side as the wire. If you get it into the right part of the clip slot, you will depress the barb, and the wire and clip will slide out. If there is not enough wire left on the clip, carefully pry open the clip and solder a new end of the wire into the clip. Then carefully pry up the barb a little, and snap it back into the connector. Or scavenge similar wires and connectors from something else, and do the same, except you may have to strip and splice on a longer piece, with the right existing clip. Any splice should be soldered and shrink tubed, double layer. Let us know how it goes and we'll help more if need be. steve
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
