If you can set some more poles or put in a 2x12 for a plate on the inside of the existing poles. You could depending on snow load put 2x6 or 8 planks on for rafters at 3 foot spacing setting the lower end on another pair of 2x12's for a plate this would eliminate the nonsense of hangers and with a stub fastened in between the plates and rafter fastened to that will not be a wind issue. We have 3 pole barns built like this and all over 30 years or more old and a lean to that is over 30 years old all still standing with no issues. though we did use rough sawed lumber from the woods so it ia all built from Elm Oak both red and white as well as Ash. No permits nor inspections needed back then. I guess the fact that in MI and they are still standing says it all. No the poles are not cemented in nor a block under them just set in the ground with no settling. Clay dirt. For the lower end you could even use poles for the rafter to set on though over kill and cost for 3 foot rafter spacing. 2 2x12's on each side of the pole will hold it and bolt them after getting building up will work fine. We use 1 5/8 bolt through the pole and plates with a scab plank on the inside and a steel plate on the outside. This will allow room for a door track if wanted and the scab plank on the inside is bolted lapping about 3 feet on each end. Dad didn't trust just the pole barn nails with the brittleness of them to hold it. All the sheds have the bolted method on them. We used 20 foot 2x6's for the leanto so probably about 16-17 foot of usable width to it. I would put tape on the lap joints of the sheets if using steel to seal from water running over the laps as it gets down closer to the bottom end with snow and slush on it.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
