Posted by BarnyardEngineering on November 09, 2022 at 05:57:34 from (161.69.123.10):
Roughly one year ago I posted a thread titled "The chimney is clean" about my struggles with the wood stove at my parents' farm.
The stove is a Vermont Castings Dutchwest with a catalytic converter.
Fired it up when it got chilly back in October, and what a mess. Would not burn. Puffed smoke into the house out from under the lid until it warmed up.
So when it got warm again, I pulled the top cover off, sealed all the visible seams with a heavy bead of furnace cement, poked out all the holes in the catalytic converter grate (some were plugged), and installed new rope seal on the top cover.
Fired it yesterday. It's a whole different stove. Not even the slightest hint of smoke smell in the house. No puffing.
So knock on wood, I won't freeze to death this winter.
This post was edited by BarnyardEngineering on 11/09/2022 at 10:09 am.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.