Posted by Steve@Advance on November 03, 2022 at 18:31:07 from (99.190.215.237):
In Reply to: Chevy 6 cylinder.... posted by centash on November 03, 2022 at 17:13:05:
Working strictly from memory from a long time ago...
A 292 is about 2 inches taller, so if the 250 is still in it, you can take a hood clearance measurement.
I 'think' the 250 oil pan will fit, but never tried. The bolt pattern should be the same but could be crank clearance problems
The crank bolt pattern, bell housing bolt pattern, starter mount, all should be the same. Best look at the flywheel and harmonic balancer for external balancing, not sure, just something to check. That could be a problem as the truck flywheel is larger.
Be sure the block has motor mount bosses on the sides.
Not sure how far you intend to take the engine, but the original intake set up was not good. Center cylinders got more fuel than the ends. If it's in the budget, devising multi port injection would be a huge improvement, or at least 3 carbs or 3 throttle bodies.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.