Posted by ChristopherCT on September 07, 2022 at 14:42:58 from (68.173.232.17):
I am the new custodian of a 1978(?) IH260a TLB, which I am told is built on the foundation of a Case/IH 684 tractor. The 260a is uncommon, and some smart folks on this site have called it an orphan, with hard to find parts and mechanics who turn them away. Its true.
Many things are strong about this machine, but two mechanics have now told me the hydraulic clutch pack is probably slipping. I have reverse and some some forward power but once warm I have almost no forward power. Transmission is torque converter fw/rev with shuttle shift, (not hydrostatic). There is a clutch-dump pedal.
Long story short- I am thinking about taking a chance and adding 10-20% Lucas Hydraulic Booster and Stop Leak to see if I can inexpensively get some torque back into forward gear. (When I bought this machine, I only drove it on flat land at 40 degrees f. It had more torque then, and I think the oil must have been thicker.) Could this Lucas fluid addition damage my hydraulic pumps? I do imagine it will put more strain on the engine due to its viscosity.
All replies are welcome. I have contacted eight service centers and individual mechanics who all do not wish to repair my machine. And although I am mechanical, I don't think I am up for rebuilding a clutch. Could I shim the clutch plates?
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
