Posted by redforlife on September 07, 2022 at 06:29:36 from (174.210.167.182):
In Reply to: Fuse problem posted by JamesJTX on September 07, 2022 at 05:00:28:
I ran into the problem Jim.Me is suggesting on a truck (this one was a ford) one time. Truck for some reason had 2 fuse panels. One under the hood, one under the dash. For some STUPID reason, all the light fuses for the truck was in one fuse panel, and all the fuses for trailer plug in lights were in the other fuse panel. I never thought it would have separate fuses for trailer, and I knew the fuses for the truck itself were all good, and I wasted a BUNCH of time thinking I had a bad ground, bad bulbs, bad plug, bad wiring, and everything else. Finally got to reading in the book. That's how I stumbled onto the separate fuse panel, and completely separate fuses for trailer lights. Sure enough, blown fuses there was all of my problems. I was so MAD!!
Only reason I can think for separate fuses, is safety. If you lose them on the trailer, you don't lose them entirely on the vehicle. But you'd think it'd be spelled out a little better than in fine print 2/3rds of the way through the owners manuel. They could of idiot proofed it a little better than that, LOL. Like printed it on one fuse lid that trailer fuses in separate panel, or something. GESH. It cost me most of a day, when I found one set of light fuses were all good, and didn't know there was a whole second set of em in a separate box.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.