I must be one of those ..older guys.. that have replaced rope seals with the engine in the unit, cars and trucks mostly. They are tricky, it is kind of like the birthing process of fitting something big through a small hole. If you are doing a ..restoration.. to me that means you would be splitting the tractor anyway to restore the clutch to original specs. Most likely you are doing a ..rehabilitation.. where if something works okay it is not touched. Anyway to split it safely you need a splitting stand or at least a facsimile of one. Do a web search for one. On an M you can get by with a couple of 6 channel iron that are long enough to go from the side frame rail rails to the floor. Bolt them on each side as far back as possible. Then put your ..2 TON plus GOOD floor jack that does NOT LEAK down.. under the clutch housing so you can roll the back half back. This is actually the marginally safe method. The best way is to have the front part of the stand that bolts below the engine equipped with heavy casters. Then to also have the ability to adjust the height of each side with a jack or threaded adjustment. Then a bottle type jack is used under the clutch housing and in this configuration the engine rolls forward. If you are used to automotive stuff BE CAREFUL comparatively the parts of this machine are heavy! Not sure if you are familiar with it but I am adding a link to the manufacturers online parts diagrams. To see the rough configuration of the rear crank seal go to Engine and subsection 014. Best of luck!
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
