Follow 550 Doug's PDF. Your rear wheels are set too wide and the long bar on the plow hitch needs moved over to line up with the center of the middle bottom. Keep in mind that 14 plows were design to plow at 1/2 of the width of cut- 7. The 2 levers are to set the plow level when plowing. When laying out a land, raise the furrow wheel lever most of the way up, set the land wheel to cut about 7 deep. After laying out the land, lower the furrow wheel lever enough to make the plow pull level. When set correctly, all furrows should be even with the last pass. The front bottom needs to set to cut 14, not 10 and not 16 or 18. the rolling cutters should be set 3/4 of an inch wider than the plow share and run 1/2 of the depth of cut. Keep adjusting the levers until you can't tell from looking across the field which pass you made before. You will probably need to add a wheel weight or 2 for traction. Plowing is a lost art and is fun when everything is set right. It would be easier if I could be there to help you get it set up instead of trying to type it all out. Good luck, post pictures when you get it going. Chris
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.