Posted by rweller@eeft.com on July 02, 2022 at 08:59:21 from (165.225.58.102):
i have a 4230 JD that's having two hydraulic problems. 1st problem is the low pressure line from the power steering metering pump (mounted at the bottom of the steering shaft) and the steering valve (mounted on the engine side of the firewall just above the motor) is blowing due to high pressure after the tractor has ran about 2 hours with a disc mower or baler - doesn't happen if ran at lower rpms. I read from someone's post that the check valves in the steering valve could be worn and causing the high pressure to push to the low presure side so we replaced the steering valve - unfortuntately, that didnt solve the problem. A deere mechanic suggested that the check valve in the metering pump may be worn and when the hydraulic oil gets hot, it passes thru the check valve easier - leading to the bleading of the high pressure side to the low pressure side. PS- the metering pump on this 4230 has niples on the low pressure fittings rather than the JIC fittings that they put on later models.
2nd problem is pressure release on single action cylinders. I have a high-capicity rake which has single action cylinders to raise and lower the raking wheels. The hydraulics work fine to raise the wheel frame, but when i go want to lower the wheels to rake by releasing the presure on the cylinder, the hydraulics do not bleed back to the hydraulic system.
if anyone out there knows what the problem is, i woudl greatly appreciate it. Thanks for the help.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
