Posted by prairiefarmer on June 26, 2022 at 20:47:08 from (107.77.206.200):
I got an early model 4020, has been shifting a little rough and when you shift to 8th gear you would shift all the way into 8th and then have to bump gear shift up maybe 1/8 inch before letting clutch out or it would just grind and not go into gear. Linkage is getting worn so i thought I'd try to adjust it. Now ive got something outta whack. Tractor wont go into any gear whatsoever. If motor is NOT running, everything shifts fine and tractor will go into any gear. As soon as i start it any try to shift, transmission makes an awful grinding noise and wont go in any gear. If i put it in gear with engine off and hold down neutral safety switch tractor will start and stay in gear, BUT even if i push clutch down the tractor will not even try to stop, you gotta kill the motor. Is this a tranny problem, or clutch problem? Tractor was fine other than sloppy shifting before i tried to adjust this. I tried adjust linkage according to shop manual to no avail. What went so terribly wrong by making a small adjustment??
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
