Dash lever set to idle, the carb should be fully closed against the idle stop.
Dash lever set for fast, the throttle should be in the wide open position.
Inspect the linkage and throttle shaft. There should not be excess wear in any of the pivot points, nothing touching the linkage, binding, rubbing, etc.
Start the engine, again the throttle should be held against the idle stop when the dash lever is at idle, not the governor holding it at idle. If the governor is holding it at idle it will be prone to surge and not idle consistently.
Bring the RPM up to full governed speed. Manually push the throttle closed at the carb. When the engine idles down, release the throttle. It should instantly spring wide open and modulate down to the governed speed.
If it is surging, try richening the mixture.
Keep in mind, the governor's sole purpose is to maintain the selected engine speed. It can only work as well as the engine allows. If the engine does not respond to throttle position, the governor doesn't care, it just positions the throttle.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
