Posted by 300jk on June 17, 2022 at 16:36:11 from (172.58.238.206):
We have a 479 New Holland haybine. Dad usually cuts hay we rake and bale together. Well today while I was at work dad was going to knock down 10-15 acres. Didnt happen. Haybine wouldnt cut well and plugged up. At 80 years old, and his limited physical ability he wasnt able to get it going again. I understand that. Brother in law to be came over and got it unplugged. I guess dad had an issue 2 days ago with it not cutting well. He had my brother come over and try to sharpen the knives in place with a 4 inch grinder. Apparently that didnt work. I have not been there. Work starts at 6 am and not getting home till 7 or 8 and its well over an hour away before anyone says I should have taken care of it. So question do you guys sharpen your knives, buy a complete bar with knives, or just replace the knives? Im guessing just replace the knives. Last time when dad was more agile he replaced the entire bar which had new knives. Like I said dad was always in charge of cutting and I raked and baled. I should know this after making hay for 30 years, but that was his thing and I never questioned what he did. Sorry so long.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.