Posted by SoulFate15 on May 26, 2022 at 20:29:14 from (64.33.71.43):
Hey everyone, first post here. I recently Bought a farmall H that that has been converted over to 12 V with live hydraulics. When I bought the H it wasn't running and the the crank pulley was stuck. I freed up the crank pulley several days back and and sprayed some WD40 in the spark plug holes to hopefully loosen up any rust that might be in there. The next day I did a compression test on all 4 cylinders and they were all 4 at about a 105 to a 110. I now have spark to the engine and I have fuel to the engine but I'm not 100% sure I'm in time as it sputters and backfires and still won't run. When starting the engine After about 3 seconds the engine will stop turning and the starter will whir. I've also noticed that oil is spewing up out of the air stack. I have checked and I don't seem to have any stuck valves. I am 22 and very new to older engines. Any help would be greatly appreciated.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
