I am surprised you can get it at a 7/11, and at that price.
Just out of curiosity. You said you have everything else required to burn kero. Do you have the right manifold, and is it functional??? A kero burner requires a manifold that channels the exhaust around the intake tubes, to preheat the intake air before it enters the head. There is a mechanical flapper inside that will direct exhaust around the intake, or directly out the upper manifold when burning gas. These are notorious for seizing up (rusting solid), so it can't be manuevered anymore. It's near impossible to find a used kero manifold that is still functional. Not sure what the situation is, on finding an aftermarket one. Guessing higher than heck, even if you can find one.
That is probably a bigger damper on people trying to do what you are doing, than the situation with the head and pistons.
You do realize that to burn kero, tractor has to be warmed up on gas, to near hot, to make the switch to kero? And then on shut down, it has to be switched back to gas, and let run long enough, that gas is what is in the carburetor. If not, the tractor won't start when cold, with kero in the carb. Not that big a deal if running the tractor all day. But to just putter around, never running the tractor very long at a time, it is pointless to mess around with that hassel. Kind of senseless to make the kero switch, when if otherwise, you'd already be shutting the tractor off.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
