Posted by martin240 on April 03, 2022 at 14:18:55 from (83.88.107.69):
Hello.
I have just bought a 1975 JCB 3D mk II for restoration.
I would like to ask if someone can give me an advice for which front tyre it must have. The manual says 12.0 x 18, but it is mounted with 9.0 x 16 on the rims usually found on the 3C model. The rear tires is 18.4 x 26.
Today it seems that 12.5x 18 is a common size, with an outer diameter of 99 cm, and a less common but available size of 12.5/75 x 18 which is 94 cm in diameter. The 9.0 x 16 is 85 cm in diameter.
Would it be a problem to raise the front by at least 5 cm when mounting 12.5/75 x 18 ?
When I see pictures of the 3D mk II model, it seems like a low profile 18" tire used in the font, where a 12.5 x 18 really looks bigger.
As far as I can figure out, the 18" rim must have a negative ET of -50 mm or something like that.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.