I am only familiar with the Power Trol on the very late A which might be the same as the Power Trol on a 60 only the 60 has live power. With dummy plugs in the back, meaning the L port and the one below it you should have rock shaft action. We had a loader plumbed to the side port on a 51 A with dummy plugs in both ports in the back. The rock shaft and loader both worked at the same time. To isolate the rock shaft so it worked without the loader raising too I put a shutoff valve in the pressure hose going to the loader. That way I could raise the loader half way up like you want to do, shut the valve in the pressure hose to the loader to hold the loader up and then the rock shaft could be used as normal. The loader was taken off the A fifty years ago so my memory has had 50 years to lose touch with what I actually did to make this work.
If you post this question on the John Deere section on this site you will get the attention of guys who know exactly what to do instead of someone like me who only knows 3/4 of what to do. LOL
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
