Posted by tom upton on January 23, 2022 at 10:57:35 from (204.237.2.83):
Attached pics show how we used to thrash back in the late 50's, 60's and even into the 70's. I have never heard of anyone else thrashing this way. Anyone on here done it like this or heard tell of anyone doing it similar? So I am pretty sure its because Dad had invested a lot of money into new Dion harvester, wagons etc and had a kind of partnership on the Dion thrashing machine with my uncle Harold Meyers ? Unfortunately I don't have a good pic of the machine as its in on the barn floor. I am sure that by the time the grain had went thru the harvester and then the blower to blow it into the thrashing machine there wasn't much thrashing left for the machine to do! Dad claimed there was very little grain loss, and he did it like this for two decades, so I guess it worked well for him. Worst part to me was forking loose straw out of the mow down to the barn floor then down the hay chutes then bedding up all the pens. When I'd complain Dads answer was usually forking a bit of straw in the winter is a lot easier than stook thrashing.
sorry not sure why its posting pics multiple times?
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.