How many miles are on it. I find it hard to marry a high mileage engine and I don't have to anymore : )
That being said if I fell off the wagon I would want to know if the oil pump builds oil pressure off the starter on cold crank up. I would disable the ignition and fuel pump install an adapter between the oil filter and block. As soon as it started to crank I should immediately see oil pressure of at least 15 to 20 psi. If I did not I would be looking from the filter toward the oil pick up. If I did the issue is from the filter to the internals of the engine.
5.3 are a little different I have never been into one I have had the oil pans off if it gets deeper GM sales a nice reman : ) I have seen 6.0's (non DOD) have good oil pressure at the filter but none at the oil sender I passed on them life is good...
Its not a anybody's game to play it can cost you thousands to allow a inexperienced wrench to learn as he goes. He can be a well seasoned veteran that does not understand how to check a oil pumps operation and throw parts at it.
The kink in it not all will be the same its all going to be how you interbit it. Pattern failures will bit you hard... Signs signs everywhere a sign as Sprint said I want to see what the top of that oil filter looks like castech heads are not. If the oil filter mount is gummy the rest of the engine is gummy : ( I have had my belly full of gummy engines move on life's to short to mess with them...
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
