If the engine has not set very long, you MIGHT get lucky trying this method. Remove the rack screw and all shims from rack end. Loosen ALL SIX injector line nuts at injectors, and tap the lines to MAKE SURE they are not stuck in the injector due to the Ermeto line ends used as they will be tight. Thread a metric bolt in the rack end to be used as a handle, if I recall it's M6 X 1.0 metric thread. Now, while cranking engine over, pull/push the rack bolt and see if it will move at all BY HAND! If it does begin to move, you are lucky. Keep working with it while cranking engine, it won't start with all the lines loose so don't worry about engine running away. If all six plungers work free, then the throttle SHOULD move rack in/out when all is right. If you do get to that point, replace the rack end screw, leaving off ONE thick shim. Replace the cap, tighten all six injector lines and start engine. If the rack DOES NOT free up pump will need removed for further inspection that can't be done on engine.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.