Posted by Tractorcedric on December 18, 2021 at 17:22:30 from (63.248.39.248):
Had a Ford dealer put new tires on the Jeep today. Tech ran the nuts down with a battery operated impact while jeep was off of the ground. I was watching to see if he would torque them. As I could look threw a window I saw the Jeep trying to roll forward as he torqued the right side wheels. He was a small guy and it sure looked like a lot of torque from were I was standing. Anyway when he got to the side were I could see him, he looked at his HIGH tech torque wrench and decided to reset it. He did not know that I was watching. I noticed that the Jeep moved a lot less as he tightened the left wheels. When he brought his work ticket to the service writer, I asked him why he changed the setting on his torque wrench. He said it was set at 130 ft. lbs and should have been 115 ft. lbs. The owners manual calls for 95 ft. lbs. The wheels are aluminum. What would you have done? I have been using a Snapon clicker torque wrench for 40 years. Hope this does not stir up too much of a stink!
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.