Posted by fixerupper on December 18, 2021 at 15:14:29 from (100.42.82.64):
In Reply to: tin roof condensation posted by 37 chief on December 18, 2021 at 14:06:24:
The new building I had put up a year ago has a combination of ventilation and special roofing steel to eliminate the drip. The roofing steel comes with a thin layer of felt blown on the underside. It's purpose is to soak up the condensation so it does not drip. The condensation that is trapped in the felt is supposed to evaporate after the roof warms up. The building contractor recommended having an overhang with vented soffits on the building to keep air moving in the roof area to dry the felt. I agreed to a 24" overhang all the way around the building with a fully vented soffit and a six inch screened in gap on the top of the walls to keep birds out of the soffit. So far I am very happy with it, the building stays dry to the point of being dusty in any weather or season and I haven't seen one drip on any of the machinery inside the shed. The steel machine shed we have across the road rains on everything inside when the conditions are right and it never does get completely dry. Both buildings are dirt floor and sit on an elevated pad.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.