Posted by wore out on December 10, 2021 at 06:31:43 from (64.255.159.199):
In Reply to: Ford 8n low oil pressure posted by Midwest farmer on December 09, 2021 at 20:06:36:
[quote="Midwest farmer"](quoted from post at 21:06:36 12/09/21)
"good gears inside"
Define "good gears".
Did you mic them and check against correct tolerances?
Did you verify there's only a few thousandths of clearance between the gears and the cover with Plastigauge?
(The reason I ask this is that there have been reports of aftermarket replacement gears being sold made to incorrect dimensions.)
Go down lower on the page and ask about this on the "N"-specific Board, contributor "TOH" is the GURU of these pumps.
Did you replace the bushing and have it bored to size correctly?
Be aware that (as with any gear pump) if the shaft bushing was badly worn the gear will contact the housing around it and mill it away. Then, when a new gear, shaft and bushing is installed the gear will again be centered, leaving excess clearance between the teeth and housing in that worn area, resulting in an internal oil leak resulting in less flow/pressure to the engine.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.