Posted by wore out on November 23, 2021 at 21:59:36 from (64.255.159.199):
In Reply to: spark coil questions posted by Bob N.Y. on November 23, 2021 at 14:06:20:
Quoting Removed, click Modern View to see
X2 to what Jim wrote!
"Youtube is not always correct!!!
"The markings on a coil with the primary terminals labeled "BATT" and "DIST" will only be correct when it is used on a system of the same ground polarity as the machine it was designed/sold for."
It's easy to determine if the spark polarity is correct with an ignition oscilloscope (but you probably don't have one, LOL), the voltage spike that leads up to the firing of the sparkplug is "negative-going" when coil primary polarity is correct.
If you are a bit more adventurous you can use the "pencil test" to determine spark polarity!
"A quick simple check for correct coil polarity can be made with an ordinary "lead" pencil.
Place the lead of the pencil in place between the spark plug wire and the plug.
Start the engine and observe the spark (fig. 6-52).
If it "flares" or has a yellow tinge on the plug side, polarity is correct.
If it "flares" or has a yellow tinge on the wire side, polarity is reversed.
I'll leave it to you to figure out how to hold/support the pencil without getting a shock!
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.