Posted by db4600 on November 22, 2021 at 08:15:44 from (174.199.38.219):
In Reply to: Buried farm machinery posted by Charlie M on November 22, 2021 at 06:33:35:
Three thoughts here: When I saw your heading it made me think of the fast hitch carry all I dug out of the edge of the rock pile. Cleaning up last month on the place we bought 16 years ago. I hooked into the angle frame and planks and by the time I was done I had the whole frame with the fast hitch teeth.
The farm I grew up on had many springs. In the right years we could work ground deep into low spots and get stuck on the side hill. Not just stuck, but fall in stuck. Now with bigger equipment there is bigger stuck.
Years back before da MeTube there was a local farmer who had some old JD sheet metal. He cut an old rear tractor tire in half and painted some card board yellow. He set the sheet metal and tires w/ the painted card board a ways off the road so it appeared he dropped in. To sell the ploy he parked the old spreader about 10 feet behind w/ tongue on the ground. He quickly became the talk of the coffee shop. The next week the local small town paper had a picture with a short explanation and then the joke was on the coffee clutch.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.