Posted by andy r on November 02, 2021 at 05:31:36 from (208.126.193.44):
Went to turn on an aeration fan yesterday and looking out at me was a rat. There are no constant feed sources on this farm as there is no livestock and I keep grain cleaned up fairly well. There are a couple cats around the farmstead as well. I believe the rat(s) can slip through the grill on the fan and of course live under the air floor. Foundation is good on the bin. They probably are living off of the fines that fall through the perforated floor plus what they might carry in. Next summer my plans are to take the floor up and clean under it. The fan is a good foot off of the ground, but I am positive that is where they enter. I thought I could put a plastic tub filled with used engine oil under the front edge of the fan and drowned them as they come out. So my question is are rats nocturnal? Are they roaming at night and in their shelter during the day? Just trying to catch them in the tub when they come out. Also, I do not want to drive them to another building. I would be willing to take the tub away and move it back during a 24 hour period so I could catch them all if some weren't in the bin at the time I placed the tub. I will certainly set some bait stations as well. Eventually I will put some screen on the fan grill. Any ideas appreciated.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.