Posted by andy r on October 12, 2021 at 08:16:20 from (208.126.193.44):
I just wanted to get ideas on how any of you have installed lights in your machine sheds. I have a 45' by 88' machine shed with 14' tall walls. Two electricians have said to put two runs of lighting the length of the building. Each run would be 1/3 of the distance from the outside walls. The rafters are on an 8 foot spacing so a light would be on every other rafter. Five rafters would have two lights hanging on them each 1/3 of the distance from the outside wall. The front half of the building would be on one switch and the rear half would be on another. The light fixtures would be the typical screw in bulb type. I would use the screw in LED lights that have the panels of light emitting diodes. Was thinking about using 14,000 lumen bulbs. Ten of those should provide plenty of light at a fairly economical operating cost plus they would power up immediately in cold weather. I like the bulbs that have four adjustable panels each so that the light could be focused somewhat downward. I have big sliding doors on each end so 10,000 lumen LED exterior lights will also be installed there. Any other ideas? Thank you.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
