I've seen that problem with the conventional power steering gear type steering box.
In my case, an aftermarket steering wheel had been installed which allowed water to go down the tube and pool on top of the seal area, which in turn rust pitted the shaft and caused the seal to leak.
You should be able to replace the seal. If you have to take the Orbitrol unit apart, be very careful to mark how each component comes apart. Take pictures and mark everything, as it will go back many ways but will only work when everything is exactly as it belongs. Learned that lesson the hard way!
If the shaft is rust pitted, try to use a wider seal or install the seal so it runs on a fresh area of the shaft. And find a double lip seal so to keep water and grit from getting down to the seal area. I was able to use a Speedi Sleeve on mine, but depending on the design that may or may not work on an Orbitrol.
When I replaced the seal in mine, I drilled a hole at the bottom of the tube to let water out. Don't know if that will apply to yours.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
