Posted by rrlund on September 10, 2021 at 16:11:26 from (69.36.63.37):
I had something happen to a loaded 18.4 38 radial that I still can't get my head around. Brian the tire guy has fixed thousands of tractor tires and said he's never seen anything like it.
I was chopping yesterday, stopped to change wagons and a tire was leaking chloride around the stem. I called and all the service trucks were out, so he didn't get here until this morning. When he looked at it, he thought the same thing that I did, that the rim was rusted and had cut in to the tube. He had a heck of a time unscrewing the outer part of the stem, then couldn't get the tool screwed on to it to suck the chloride out. He just kind of had to hold it up against it and let it suck air and chloride until he got it down far enough to break it down, slit the tube and suck the rest out that way.
When he pulled the tube out, the brass part that's vulcanized in the rubber part of the stem stayed in the hole in the rim. He had to wiggle it around and then it came right out. There was a big groove worn right in to the side of that brass stem. At least half way in. It must have flexed just enough in that radial tire to eventually wear into it. The rim was fine. The hole looked like new. The rubber part of the tube must have been sealing things up just like the stem in a tubeless tire for all those years until something finally flexed just enough to break the seal.
Brian tossed it up in the back of the truck after we looked at it and pondered what must have happened. I wish now that I'd have kept it or at least taken a picture of it. Unreal how that tire stayed up for so long after that hole first wore through.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
