Posted by Inanecathode on September 07, 2021 at 19:07:58 from (75.35.0.63):
I've got a ferguson ABO-22 disc that I've been pulling with my old 8n. Everything has worked as good as it can for a 80 year old tractor pulling a 70 year old disc. The rear left gang of disc's has historically been an issue with occasionally binding. The lower bearing had a chunk missing since Nixon from the looks of it but nothing way too much grease couldn't fix.
Welp. I was apparently in a big hurry and whipping through a gate opening, caught the left rear outer disc on a fence post and the fence post won. The upper bearing box mounting bit thing snapped totally off from the rest of the gang frame.
So what I'm looking at is a bearing box lower that's in a few pieces, a bearing box upper that's in a few more pieces.
I entertained the thought of welding it back together but I'm pretty sure it's all cast iron and without a ton of heat it won't not crack.
I've done my best google fu an all I can find is symmetrical looking bearing boxes but nothing that has the offset looking mount from the upper box to the gang frame.
Is this even something that's replaceable? Should I try welding it? I'd hate to scrap the whole thing for just this one part. Am I able to just take that gang off and have a janky three gang disc? Just take the other rear gang off and run the front gang?
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.