Thank you IA farm guy! You got the basic parameters right! There are currently three classes, Antique, requiring all mechanical plows with blacksmith plow shares in as original a condition as possible( rubber tires on cut down steel wheels are ok) tractors 1951 and older( I'm not sure of the year and don't have my rule book handy) The open class, basically any tractor and plow combination as long as it is not a designed competition plow I.E. Kevernaland, Fiskars, etc.. Small plow class where within some limits anything goes for equipment( no modern electronic aids, GPS, auto steer etc allowed). The pre qualifying part is essentially accurate for the national contest, you would be able to compete in the state contest on Wednesday, but it would be good to let us know so we can plan for allocating practice and competition plots. Actually there are four classes there is a class for reversible plows too but there are only a few people who compete in it. Plows are generally 2-3 bottom pull plows in the antique and open class, but 4 bottom and larger can compete too. Please feel free to come join us, it is an enjoyable way to use your vintage machinery.Please visit our web site for more detailed information! Thanks agin Mike
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
